Comparison of different etch-and-rinse adhesive systems based on shear fatigue dentin bond strength and morphological features the interface

Yuta Kasahara, Toshiki Takamizawa, Eizo Hirokane, Akimasa Tsujimoto, Ryo Ishii, Wayne W. Barkmeier, Mark A. Latta, Masashi Miyazaki

研究成果: ジャーナルへの寄稿記事査読

10 被引用数 (Scopus)

抄録

Objectives: The aim of this study was to investigate dentin bonding durability of different etch-and-rinse (ER) adhesive systems under fatigue stress and to compare morphological features of resin/dentin interfaces using SEM. Methods: Two three-step ER adhesives, a two-step ER adhesive, and a universal adhesive in ER mode were evaluated. Before application of either primer or adhesive, phosphoric acid etching of human dentin was completed. Fifteen bonded specimens for each adhesive system were stored in distilled water at 37 °C for 24 h, then subjected to a shear bond strength (SBS) test. Bonding durability was assessed from the perspective of biomechanical stress. 25 bonded specimens for each adhesive system were subjected to shear fatigue strength (SFS) testing with a repeated subcritical load at a frequency of 20 Hz for 50,000 cycles or until failure. Results: Mean SBS and SFS values ranged from 33.3 to 41.2 MPa, and from 18.3 to 20.3 MPa, respectively. Three-step adhesives showed higher SBS and SFS values than the other adhesive systems. Under SEM, resin tags in different adhesive systems showed similar features, but morphology below the hybrid layer was material dependent. The universal adhesive in ER mode showed an obvious thin, high-density reaction layer below the hybrid layer. Significance: Three-step adhesives showed higher dentin bond durability than the other ER adhesives; no significant differences in SFS were found between the universal adhesive in ER mode and the three-step ER adhesives. The results of this in vitro study indicate that some ER adhesives might establish chemical bonding with intact dentin below the hybrid layer in addition to micromechanical retention.

本文言語英語
ページ(範囲)e109-e117
ジャーナルDental Materials
37
3
DOI
出版ステータス出版済み - 3月 2021

フィンガープリント

「Comparison of different etch-and-rinse adhesive systems based on shear fatigue dentin bond strength and morphological features the interface」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル